VPS 및 전용 서버(호스팅 컨트롤 센터) 도움말

Adding IP Addresses to Your Windows 2008 Server (Loopback)

Warning: Do not complete these steps if you have a Virtual Private Server (VPS).

We have multiple configuration methods for our servers' networking. To make sure you use the correct procedure when configuring additional IPs on your server, please see Add more IP Addresses.

Some of the information in this article is advanced material we make available as a courtesy. Please be advised that you are responsible for properly following the procedures below. Customer Support cannot assist with these topics.

When you receive additional IPs for your server, you have to configure your server and firewall to accept requests from them.

Note: We configure all of your server's IP addresses automatically whenever you reprovision your server. However, reprovisioning erases all content from your server's hard drives. For more information, see Starting over with My Server (Reprovision)

We automatically configure additional IP addresses for Virtual Private Servers (VPS) — do not complete these steps.

To Add IP Addresses to Your Windows 2008 Server

  1. Access your server via Remote Desktop.
  2. From the Start menu, select Network.
  3. In the upper-left, double-click Network and Sharing Center.
  4. On the left, click Change Adapter Settings.
  5. Note your local area connection name for a future command. It resembles Local Area Connection [X].
  6. Right-click Loopback, and then select Enable.
  7. Right-click Loopback again, and then select Properties.
  8. Select Internet Protocol Version 4 (TCP/IPv4), and then click Properties.
  9. Select Use the following IP address, complete the following fields, and then click OK:
    • IP Address — Enter your server's new IP address.
    • Subnet Mask — Type 255.255.255.255.
  10. From the Start menu, right-click Command Prompt, and then select Run as administrator.
  11. Run the following commands at Command Prompt:
    netsh.exe
    interface ipv4 set interface "[local area connection name]" forwarding=enabled
    Where [local area connection name] is the local connection area name you noted from the Network Connections window. For example "Local Area Connection 5."
    interface ipv4 set interface "loopback" forwarding=enabled
    exit

이 글이 도움되었나요?
피드백을 보내주셔서 감사합니다. 고객 서비스 담당자에게 문의하시려면 지원 전화 번호 또는 위의 채팅 옵션을 이용하시기 바랍니다.
도와드릴 수 있어 기쁩니다! 더 도와 드릴 것이 있나요?
그것 유감스럽습니다. 혼동이 되었던 사항 또는 솔루션이 고객님의 문제를 해결하지 못했던 원인을 알려주세요.